Texas A/S Snow King 565 TG Anleitung Seite 22

STEP 4 - Inserting the gear lever
The gear lever is now ready to be inserted. Insert the gear lever through the gear bracket
STEP 5 - Transmission shaft
Attach the other end of the gear lever on the transmission shaft, secure with pin. Too much tension
may damage the transmission.
STEP 6 - Chute assembly
When the chute is assembled it should rotate easily without any friction. If not, check whether the
plates are fastened too tight. Ensure that the different types of plates are in the right sequence.
See picture above. The auger screw can be adjusted to move it in or out for screw engagement. If
turning the chute handle cause the screw to jump over the chute teeth move the auger screw in by
unloosing the support bracket screw and pushing it in.
Emergency stop
Release the dead man levers and shut off the engine switch.
22