Advanced Bionics Naida CI Q70 Gebrauchsanweisung Seite 57

If no lights appear:
Check that the LED is not obscured by the user's clothing, hair, and/or, processor wearing device.
1
Verify that the PowerCel is seated properly on the processor, or, if using Zn-Air Battery Pak,
2
verify that the batteries are inserted correctly.
Replace the battery.
3
Verify that the Naída CI is not in Standby Mode by briefly pressing the program button.
4
If green LED does not flash in response to loud sounds (programmable feature):
Confirm that this feature is enabled on the processor/program.
1
Verify that the PowerCel is charged and is inserted properly on the processor. If using Zinc
2
Air Cells, verify that the cells are new and inserted properly within the cartridge.
If paired to an AB myPilot Remote Control, check the sensitivity setting, or try increasing it
3
slightly for assessment purposes only.
Try another program slot.
4
Try another audio source (such as the T-Mic 2/processor microphone/headpiece microphone)
5
Unaided listeners may perform a listening check of the audio inputs as described in the
6
Listening to the Microphone and Auxiliary Inputs
Try another auxiliary source.
7
You will need a program which accepts input from external audio sources and to have
a.
wireless enabled on the processor.
If the green LED flashes in response to input from an external audio device, place the
b.
processor and headpiece in the Zephyr by Dry & Store. If the green LED still does not
flash in response to loud sounds following a full drying cycle and when using the usual
microphone input and usual program settings, proceed to the next step.
If the headpiece microphone is the only input that does not show a blinking green LED, replace
8
the headpiece and/or cable. If T-Mic 2 is the only input that does not show a blinking green
LED, replace the T-Mic 2. If the processor microphones do not show a blinking green LED
with audio input, contact a hearing care professional or Advanced Bionics.
During battery status check, no blink or only one orange blink is observed:
Zn-Air batteries will NOT give the LED battery status upon start
ReMeMBeR:
up. Only the rechargeable PowerCels will give the LED battery status read out.
Verify that the PowerCel is seated properly on the processor.
1
Replace with a fully charged PowerCel.
2
56
Naída CI Sound Processor User Guide
section of the User Guide.