Advanced Bionics Naida CI Q70 Gebrauchsanweisung Seite 38

Insert the AB logo portion into the other
portion of the Naída CI Listening Check.
You should feel the two portions snap into
place. Once in place, the processor and
PowerCel connectors will be exposed.
Connect the bottom of the Naída CI
Listening Check to the power source
(PowerCel, Zn-Air Battery Pak, AAA
PowerPak).
Place the earbuds in the ears of the unaided listener.
7
When the Naída CI Listening Check is attached, the processor immediately enters listening check
8
mode. If you are not using an AB myPilot to select the input sound source, you will be listening to the
input sound source configuration of the first program. If you would like to listen to the other
program sound source configurations, use the program button to cycle through the programs.
If you are using an AB myPilot, select Listening Check from the AB myPilot menu and
9
select the input sound source to which you would like to listen. Alternatively, if the Naída CI is
already connected to the Naída CI Listening Check and paired to the AB myPilot, the AB myPilot
will go to the Listening Check screen once it communicates with the Naída CI. This can be done
by briefly pressing the power button on the AB myPilot. Once the Listening Check screen is shown,
you can use the left and right arrows to listen to program configurations and the sound
sources independently.
If you select T-coil, make sure you are synced to either a loop or myLink. Provide input to
a.
3
5
4
Connect the top of the Naída CI
Listening Check Module to the processor
6
Connect the supplied earbuds to the
3.5 mm auxiliary jack on the side of
the Naída CI Listening Check.
Naída CI Sound Processor User Guide
37