Very Important - Fagor CG7-20 Allgemeine Bedienungssanleitung Zur Installation Bedienung Und Wartung

∗
The positioning and electrical and gas installation should always be carried out by an AUTHORISED
TECHNICIAN, observing the standards of each country.
∗
It is advisable to install an extraction hood for the optimum operation of the appliance.
∗
Place the appliance in a well ventilated place.
∗
Level and adjust the height of the appliance.(Fig. 1) and (Fig. 1A)
The appliance's electrical connection must always be carried out by an AUTHORISED TECHNICIAN, observing the
regulations in each country.
∗
Check that the mains voltage corresponds to that indicated on the name plate.
∗
Use cable sleeves made out of polychloroprene or other similar materials (H05RN-F), for the connection.
∗
A switch device should be installed next to the appliance for all the phases, with a gap of a minimum of 3
mm between contacts. This switch will be equipped with fuses.
∗
It is obligatory to earth the appliance. The manufacturer will not be held liable for damage originated by
failure to observe this requirement The section of cable sleeve and the rating of the fuses to be installed in
the power switch are indicated in diagram no. 2.
∗
The position of the terminal strip is indicated with the letter "R".
VERY IMPORTANT: Before installing the control panel, attach the electrical supply cable securely to the stuffing box.
When several appliances are installed in series, they should be earthed to each other using the point assigned for
this purpose, located in the appliance's base, at the back.
The appliance's gas connection must always be carried out by an Authorised Technician, observing the regulations in
each country.
The general installation must have a stop-cock and a pressure regulator and it also advisable to install a shut-off cock
on each individual appliance.
The gas inlet is defined in the "General and connection dimensions" section with the letter G.
If the appliance is prepared for a different type of gas to the one available in the installation, you should proceed as
follows:
Cut off the gas to the appliance if connected. (All conversions of the appliance's gas circuit must always be carried
out by a QUALIFIED TECHNICIAN).
Table and oven burner conversion
Injector replacement.
Dismantle the "A" injectors (Fig. 3) and replace them with suitable ones depending on the gas to be used (Table 7)
Burner air adjustment.
Position the air regulator "C" (Fig. 3) to the "H" measurement (Table 7) depending on the gas to be used.
Pilot conversion
To convert to NATURAL GAS, please proceed as follows: Loosen screw "A" of the
The 0.25 mm injector "B" is underneath screw "A", which must be loosened and replaced by the 0.40 mm injector
supplied with the nozzles.
Turn the air regulator "C" until the flame steadies.
To convert to TOWN GAS, the adjustment of the pilot flame will be carried out turning the adjusting screw "B" until the
flame is stable.
1.-INSTALATION:
Positioning and levelling
Electrical connection
Gas connection
Conversion to different gases
34
Fig. 4 (detail A).