Troubleshooting - Grundig GTN 37250 G Bedienungsanleitung

Troubleshooting

8
Drying process takes too much time.
Pores of the lint filter are clogged. >>> Wash the lint filter with warm water.
ƒ
Filter drawer is clogged. >>> Clean the sponge and the filter cloth in the filter drawer.
ƒ
Ventilation grids on the front side of the machine are blocked. >>> Remove the objects (if
ƒ
any) that block ventilation in front of the ventilation grids.
ƒ Ventilation may not be sufficient since the room where the machine is installed is very
small. >>> Open the door and windows of the room to avoid the room temperature
increase too much.
Lime deposit has built up on the dampness sensor. >>> Clean the dampness sensor.
ƒ
Excessive laundry might have been loaded in. >>> Do not overload the dryer.
ƒ
Laundry might not be spun sufficiently. >>> Spin your laundry at a higher speed in your
ƒ
washing machine.
Laundry comes out wet at the end of drying.
A programme suitable for the laundry type might have not been used.>>> Check
ƒ
the garment tag and select a programme suitable for the fabric type or use the timer
programmes additionally.
ƒ Pores of the lint filter are clogged. >>> Wash the lint filter with warm water.
Filter drawer is clogged. >>> Clean the sponge and the filter cloth in the filter drawer.
ƒ
Excessive laundry might have been loaded in. >>> Do not load the dryer in excess.
ƒ
Laundry might not be spun sufficiently. >>> Spin your laundry at a higher speed in your
ƒ
washing machine.
Dryer does not switch on or the programme does not start. Dryer does not
start when it is set.
It might have not been plugged in. >>> Make sure that the machine is plugged in.
ƒ
The loading door is ajar. >>> Make sure that the loading door is closed securely.
ƒ
Programme is not selected or the Start / Pause button is not pressed. >>> Make sure that
ƒ
the programme is selected and it is not in the Pause position.
"Child Lock" might have been activated. >>> Deactivate the Childproof Lock.
ƒ
Programme is interrupted without any cause.
The loading door might not be closed securely. >>> Push the loading door to close until
ƒ
you hear a locking sound.
ƒ A power failure might have occurred. >>> Press Start / Pause button to start the program.
Water tank may be full. >>> Drain the water tank.
ƒ
Laundry has shrunk, become felted or deteriorated.
A programme suitable for the laundry type might have not been used. >>> Check the
ƒ
garment tag and select a programme suitable for the fabric type.
Water leaks from the loading door.
Lint has accumulated on the inner surfaces of the loading door and on the surfaces of the
ƒ
loading door gasket. >>> Clean the inner surfaces of the loading door and the surfaces
of the loading door gasket.
60 / 64 EN
Dryer / User Manual