Adding / Removing Laundry In Pause Mode; Cancelling The Programme; End Of Programme - Grundig GTN 37250 G Bedienungsanleitung

Operating the product
Adding / removing laundry in Pause
mode
In order to add or take out laundry after the
drying programme has started:
1. Press Start/Pause button to switch the
machine to Pause mode. Drying process
will stop.
2. While in Pause mode, open the loading
door, add or take out laundry and close
the loading door.
3. Press the Start/Pause button to start the
programme.
C
Any laundry added after the drying
process has started may cause the
clothes that are already dried in the
machine intermingle with wet clothes
and the result will be wet laundry after
the drying process is over.
C
You may repeat laundry adding
or removing process as many
times as you desire during drying.
However, this process will increase
the programme time and energy
consumption since the drying process
will be interrupted repeatedly.
Therefore, it is recommended to add
laundry before the drying programme
has started.
C
If you select a new programme by
turning the Programme Selection knob
while your machine is in Pause mode,
then the current programme is aborted
and new programme information is
displayed.
cAUTIoN: Do not touch the inner
surface of the drum when adding or
taking out laundry while a programme
is running. Surfaces of the drum are
hot.
54 / 64 EN

5.12 cancelling the programme

If you want to stop drying and cancel the
programme for any reason after the machine
has started to run, press and hold the
off/cancel
button for 3 seconds.
A
cAUTIoN: As the inside of the
machine will be excessively hot when
you cancel the programme while
the machine is running, activate the
ventilation programme to cool it down.

5.13 end of programme

Lint Filter Cleaning and Water Tank warning
symbols light up in the programme follow-up
indicator when the programme comes to an
end. The loading door can be opened and
the machine becomes ready for a second
cycle.
Press on/off/cancel button to switch off
the machine.
C
2-hour Anti-creasing programme will
be activated if the laundry is not taken
out after the programme has come to
an end.
C
Clean the lint filter after each drying.
(See "Lint Filter and Loading Door
Inner Surface")
C
Drain the water tank after each drying
cycle. (See "Draining the water tank")
on/
Dryer / User Manual