Programming; Installation - Simons Voss Technologies ST10.08007M Kurzanleitung

5. Programming

NOTE
If the PIN code keypad is already in storage mode, it cannot be set to
storage mode again. In such a case, the process will be interrupted with
a red flashing light and beeping for a long time.
5 Programming
The PIN code keypad is programmed in the MobileKey web app
https://app.my-mobilekey.com
(
SmartIntego manager and in the integrator system.

6 Installation

The PIN code keypad can be installed using the supplied installation
accessories.


Install the PIN code keypad within the range of a SmartBridge (radio
range up to 30 m) (SmartIntego: SmartBridge). You'll find the specific
details in the quick guide on the SmartBridge or the MobileKey manual
(SmartIntego: TechGuide). There is no need to install within the range
42 / 184
You can use the enclosed special adhesive pad to attach the PIN
code keypad, making installation quick and easy.
We recommend using the supplied screws to secure the
component. You will need a "TX6" Torx screwdriver (not included in
the supply package) to open the housing to do so.
MK/SI PinCode-Tastatur (on-
) or for SmartIntego products in the
line)
EN