Protool DuraDrive DWC 18-2500 DEC Originalbetriebsanleitung Seite 18

into machine anti-clockwise operation.
In order to start the power tool, press the
switch [1-2]. The switch MAN/AUTO [1-4]
is in any position.
Use the switch [1-2] to gradually regulate
the speed.
CAUTION
If the forward / reverse switch [1-3]
is set to anti-clockwise operation, the
screwdriver can be started only by
pressing the switch [1-2] – without
additional pressure on the bit!
CAUTION
It is not necessary to remove the
depth stopper in order to unscrew
screws!
8.2 Depth stopper
Turning the depth stopper sets the screwing
depth – see fi gure [5]. The setting accuracy
is approx ± 0.1 mm.
Anti-clockwise rotation = screws are in-
Clockwise rotation
Upon setting the depth, set some screws
to test and adjust the depth.
Depth stopper assembly
Fit the depth stopper [4-1] on the gear box
[4-5], until it engages in the groove.
Depth stopper disassembly
Remove the depth stopper from the gear
box by pulling it.
8.3 Hook and clip
Use the clip [6-1] to temporarily attach the
screwdriver on the working clothing – it can
be attached by means of a screw [6-2] to
the left or right of the power tool, and it is
suitable for right and left handed people –
see fi gure [6].
The screwdriver is equipped with a hook
[7-1], which is used for occasional machine
suspension. It can be attached to the left
or right of the power tool, by means of a
screw [7-2] – see fi gure [7].
serted deeper
= screws are in-
serted to lower
depth
8.4 Auto feed attachment
The auto feed attachment enables to work
continuously, without unnecessary delays.
Fitting the auto feed attachment
At fi rst remove the depth stopper [4-1], bit
holder [4-2] and bit, as specifi ed in point 7.
Set the switch [1-4] into MAN position.
Push the long bit [8-1] completely to the
hexagonal spindle opening [4-4].
Then fi t the auto feed attachment on the
gear box. Push the attachment until it en-
gages in the groove of the gear box.
The attachment can be mounted at 30°
steps.
Removing the auto feed attachment
Use power to carefully pull the attachment
from the gear box.
Setting the screw length
Press button [9-1] to remove and insert the
depth stopper [9-2] and set the required
screw length. Read the set screw length on
the stopper sides [9-3].
Inserting collated screw strips
Pull the collated screws [10-3] through the
bottom guiding of the attachment, then
push the strip through the second guid-
ing until it engages in the working position.
Pull the belt slightly to make sure that it is
safely fi tted. Make sure that the fi rst screw
is in the screwing axes – see fi gure [10].
Use the wheel [10-1] to set the required
screwing depth. Turn to the right for in-
serting the screws deeper, and to the left
to screw to lower depth. The actual setting
position is visible on the presetting indica-
tor [10-2].
Upon setting, set some screws for test-
ing and use the wheel [10-1] to adjust the
depth, if required. Each setting change
complies with the stopper shift o ± 0.1 mm.
► We recommend to screw in automatic
mode – see point 8.1 b).
Removing the collated screws
Pull upwards to remove the belt (fi gure
[11] ) or press the transport lever and
concurrently pull the belt downwards (fi g-
ure [11] ).
18