Additional Requirements - Superior SONIA Installationsanleitung

LIA - LISA - SONIA - MILLY - SEFORA - MINA.
- Graft the 2 PIN terminal to the other end of the cable in position AUX 1
on the board, as shown in the stove wiring diagram.
Fig. 22
- Fix the earth cable onto the board as shown in the stove wiring
diagram.
- Graft the 2 PIN (10) terminal in position N.H2O on the board, in order
to stop the stove from operating in the "NIGHT MODE".
Fig. 23
SONIA - MILLY - SEFORA - MINA.
- Refit the cast-iron plate, the front grille and the cladding in the reverse
order of disassembly.
LIA - LISA.
- Remove the left side seal (H) by undoing the self-tapping screws that
retain it.
Fig. 24
H
- Open the tank cover and turn the sensor support pipe (I) until seeing
the screw heads. Remove the first screw (L) as shown in the figure,
making sure it does not fall into the tank.
Fig. 25
- Push the sensor inside the pipe until it touches the other screw.
- Re-mount the side seal.
12
- Re-mount the casing in the reverse order followed for mounting.
- Fix the screw (8) onto the guard (2) and thread it through the centre
of the hole cap (N).
Fig. 26

ADDITIONAL REQUIREMENTS

Additional hot air extractor fan without controls
The additional hot air extractor fan functions in the same way as the hot
air extractor fan installed as standard and the speed cannot be adjusted
manually by the user.
Make sure the ENABLE V2 menu is set to OFF.
If the HOT AIR DUCTING KIT is installed, NIGHT MODE cannot
a
be activated.
DT2034071-00
L
I
DT2034072-00
H07031710 / DT2002252 – 04
8
N
2
DT2034133-00