Basic Safety Notes; Intended Use; Not Intended Use; Spare Parts - SCHUNK EOA-TM JGP 80-1 Montage- Und Betriebsanleitung

Basic safety notes

2 Basic safety notes

2.1 Intended use

2.2 Not intended use

2.3 Spare parts

2.4 Gripper fingers

6
01.00 | ID no. 1399647 | Assembly and Operating Manual | en | 1399710
The gripper unit was designed as a version of the EOA-TM kit for
attachment to a robot with ISO-50 interface. The gripper unit with
integrated valves and sensor interface is used in the robot
application. The customer must integrate top jaws with which
workpieces can be gripped, held and released safely.
• The product may only be used within the scope of its technical
data, Technical Data
• When implementing and operating components in safety-
related parts of the control systems, the basic safety principles
in accordance with DIN EN ISO 13849-2 apply. The proven safety
principles in accordance with DIN EN ISO 13849-2 also apply to
categories 1, 2, 3 and 4.
• The product is intended for installation in a machine/system.
The applicable guidelines must be observed and complied with.
• The product is intended for industrial and industry-oriented use.
• Appropriate use of the product includes compliance with all
instructions in this manual.
It is not intended use if the product is used, for example, as a
pressing tool, stamping tool, lifting gear, guide for tools, cutting
tool, clamping device or a drilling tool.
• Any utilization that exceeds or differs from the appropriate use
is regarded as misuse.
Use of unauthorized spare parts
Using unauthorized spare parts can endanger personnel and
damage the product or cause it to malfunction.
• Use only original spare parts or spares authorized by SCHUNK.
Requirements for the gripper fingers
Stored energy within the product creates the risk of serious
injuries and significant property damage.
• Arrange the gripper fingers in a way that the product reaches
either the position "open" or "closed" in a de-energized state.
• Only exchange the gripper fingers when no residual energy
remains in the product.
• Make sure that the product and the top jaws are a sufficient
size for the application.
[ 14].
}