Protection Against Burns; Notes On Particular Risks - SCHUNK EOA-TM JGP 100-1 Montage- Und Betriebsanleitung

Basic safety notes

2.12.5 Protection against burns

2.13 Notes on particular risks

12
01.00 | ID no. 1399646 | Assembly and Operating Manual | en | 1399709
Working with hot surfaces
Depending on the circumstances the surface of the product can
get very hot and cause burns when touching it.
• Do not touch hot surfaces, such as brake resistors, heat sinks,
drive units, windings and sheet metals.
• Let the surface cool down before working with it. After
switching off the cool-down time of some components can
average up to an hour.
• Wear protection gloves.
WARNING
Risk of injury due to unexpected movements!
If the power supply is switched on or residual energy remains in
the system, components can move unexpectedly and cause
serious injuries.
Before starting any work on the product: Switch off the power
•
supply and secure against restarting.
Make sure, that no residual energy remains in the system.
•
WARNING
Risk of injury due to uncontrolled movements!
In case of malfunction of sensors, pneumatic valves, electro
distributors or bus systems, uncontrolled movements of the
product may cause serious injuries.
Connect sensors, pneumatic valves, electro distributors and
•
bus systems correctly.
WARNING
Risk of injury from crushing and impacts!
Serious injury could occur during the base jaw procedure and
when breaking or loosening the gripper fingers.
Wear suitable protective equipment.
•
Do not reach into the open mechanism or the movement area
•
of the product.