Load Fail-Safe Defaults; Load Optimized Defaults; Set Password; Save & Exit Setup - Abit A-S78H Handbuch

A mismatched configuration will cause the fan speed control function out of
※
order. Please select the correct option according to your fan type.
- FanEQ Target Temp.
This item sets the temperature mark for the "CPU FANEQ" function to take effect.
- FanEQ Temp. Tolerance
This item sets the temperature tolerance range.
- FanEQ Start Control
This item sets the speed ratio for the CPU fan assembly connected at "CPUFAN1" fan power
connector to start running.
- FanEQ Stop Control
This item sets the lowest speed ratio for the CPU fan assembly connected at "CPUFAN1" fan
power connector to run at when the CPU temperature detected is lower than the value of item
"FanEQ Target Temp." plus the value of item "FanEQ Temp. Tolerance".
In the situation when the CPU temperature detected is higher than the value of item "FanEQ
Target Temp." plus the value of item "FanEQ Temp. Tolerance", the speed ratio for the CPU fan
assembly connected at "CPUFAN1" fan power connector will first run at the speed ratio set by
the item "CPU FanEQ Start Control", and then up to 100%.
All Voltages, Fans Speed and Thermal Monitoring
These unchangeable items list the current status of the CPU and environment temperatures, fan
speeds, and system power voltage.

2.9 Load Fail-Safe Defaults

This option loads the BIOS default values for the most stable, minimal-performance system
operations.

2.10 Load Optimized Defaults

This option loads the BIOS default values that are factory settings for optimal-performance
system operations.

2.11 Set Password

This option protects the BIOS configuration or restricts access to the computer itself.
2.12 Save & Exit Setup
This option saves your selections and exits the BIOS setup menu.

2.13 Exit Without Saving

This option exits the BIOS setup menu without saving any changes.
2-18
Downloaded from www.Manualslib.com manuals search engine
A-S78H