Getting Started - Remington X Serie Bedienungsanleitung

ENGLISH
PARTS
1. Blade set
2. On/Off Switch
3. Length adjustment dial
4. Length setting window for 25 - 35 mm
comb
5. Length setting window for 14 - 24 mm
comb
6. Length setting window for 3 - 13 mm
comb

GETTING STARTED

CHARGING YOUR APPLIANCE
• Before using your hairclipper for the first time, charge for 10 hours.
• Ensure the product is switched off.
• Connect the charging adaptor to the product and then to the mains.
• When charging, the charge indicator light will light up.
• If the product is not going to be used for an extended period of time (2 – 3 months),
unplug it from the mains and store.
• Fully recharge your hairclipper when you would like to use it again.
• Allow 10 hours for a complete charge.
• Note: To preserve the life of your batteries, let them run out every 6 months then fully
charge.
CHARGING VIA STANDARD ELECTRICAL SOCKET
• Ensure the product is switched off.
• Connect the charging adaptor to the product and then to the mains.
USB
• Connect Micro USB to the appliance, and the USB connector to any standard USB port or
charger
• Product will only charge through USB and will not run in corded mode.
CORDED USE
• Connect the charging adaptor to the product then to the mains.
CAUTION Extended mains only use will result in the reduction of the battery life.
CORDLESS USE
• When the product is switched on and fully charged it can be used in cordless mode for
up to 60 minutes.
4
7. Charging indicator light
8. Charger connector
9. 25 - 35 mm comb
10. 14 - 24 mm comb
11. 3 - 13 mm comb
Not Shown:
• Adaptor
• Cleaning brush
• Oil bottle