Transport; Cleaning And Maintenance - Scheppach ETB710 Original Bedienungsanleitung

9.8 Setting the drilling speed (fig. 1)
The correct speed must be set to suit the workpiece
to be drilled and the tool diameter.
Mechanical gear selection:
Two different speed ranges can be selected with the
gear selector switch (18).
Gear 1:
Low speeds (170- 880 min ) for large tool diameters.
-1
Gear 2:
High speeds (490-2600 min
ters.
m Attention:
Actuate the gear selector switch (18) only when at
a standstill. If the gear selector switch (18) does not
latch into place turn the chuck (14) a little.
If the gear selector switch (18) cannot be turned as far
as the stop, turn the chuck a little with the drill.
Electronic speed control:
The speed of the individual gears can be seamlessly
adjusted with the electronic speed control:
Set the speed with the help of the speed control (12).
The current speed can be seen on the display (9).
9.9 Displaying the drilling depth (fig. 1/7)
1. Set the display (9) to the "Drilling depth" indication
(button F).
2. Set the tip of the drill bit down lightly on the work-
piece.
3. Set the zero point by pressing the button (G).
4. Drill until the desired depth is shown on the dis-
play (9).
9.10 Switching on/off (fig. 1)
m Make sure that the chuck guard (13) is folded
down before switching on.
Switching on:
Press the on switch (11) to switch the device on.
Switching off:
Press the off switch (10) to switch the device off.
9.11 Drilling procedure (fig. 1)
1. Align the workpiece and clamp it.
2. Start the device and set the speed.
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
) for small tool diame-
-1
3. For drilling, move the handle (8) with uniform feed
until the desired drilling depth is reached. When
drilling into metal, interrupt the downward pres-
sure briefly to break the swarf.
4. After reaching the drilling depth, return the handle
(8) to the starting position.
5. Switch the device off.

10. Transport

• To transport the device hold it by the base plate (1).

11. Cleaning and maintenance

m Warning!
Pull out the mains plug before carrying out any ad-
justments, maintenance or repair work!
General maintenance tasks
Wipe swarf and dust off the machine from time to
time with a cloth. Oil the rotating parts once monthly
to extend the life of the tool. Do not oil the motor.
Do not use corrosive agents for cleaning the plastic.
m Have tasks that are not described in this op-
erating manual, carried out by a specialist work-
shop. Use only original parts. Let the device cool
down before all maintenance and cleaning tasks.
m There is a risk of burn!
Before using the device each time, check the device
for obvious defects such as worn or damaged parts,
correct seating of screws or other parts. Replace
damaged parts.
Cleaning
Do not use cleaning agents or solvents. Chemical
substances could damage the plastic parts of the de-
vice. Never clean the device under running water.
• Clean the device thoroughly after each use.
• Clean the ventilation holes and the surface of the
device with a soft brush or cloth.
• Remove swarf, dust and dirt with a vacuum cleaner
if necessary.
• Lubricate the moving parts regularly.
Maintenance
The device has no parts that require maintenance.
Replacing the chuck (fig. 10)
m Warning! Pull out the mains plug!
Tools required:
1x open-ended spanner (flat) 16 mm
1x Allen key 2.5 mm (not included in the scope of de-
livery)
GB | 27