Connecting The Projector; Connecting A Computer; Input A/Input B - Sony VPL-CX236 Kurzreferenz

Connecting the Projector

Notes
• Make sure all the equipment is powered off when connecting the projector.
• Use the proper cables for each connection.
• Insert the cable plugs firmly; Loose connections may reduce performance of picture signals or
cause a malfunction. When pulling out a cable, be sure to grip it by the plug, not the cable itself.
• For more information, refer also to the instruction manuals of the equipment you are connecting.
• Use a no-resistance audio cable.

Connecting a Computer

Connection with a computer is explained for each input signal.

INPUT A/INPUT B

For connecting a computer with an RGB output connector.
Mini D-sub 15-pin cable (supplied)
Computer
Note
It is recommended that you set the resolution of your computer to 1024 × 768 pixels (VPL-CX236/
CX276) or 1280 × 800 pixels (VPL-CW256/CW276) for the external monitor.
INPUT C/INPUT D
For connecting video equipment with an HDMI output connector.
Computer
Notes
• Use HDMI-compatible equipment and cable(s) that have an HDMI logo on them.
• Use a high speed HDMI cable(s) on which the cable type logo is specified. (Sony products are
recommended.)
• The HDMI connector of this projector is not compatible with DSD (Direct Stream Digital) Signal
or CEC (Consumer Electronics Control) Signal.
RGB output
connector
Audio output
connector
Audio cable (Stereo mini plug) (not supplied)
HDMI output
HDMI cable
connector
(not supplied)
Connecting the Projector
11
GB