Configuration; Operation; Instructions For Use; Entering Service Data - Bosch ACS 653 Originalbetriebsanleitung

5.17.2 Configuration
To configure the CoRe function (only displayed if
enabled in the Setup Menu), follow this procedure:
1. Call up the Main Menu.
2. Select
.
3. Select
.
4. Select Connected Repair [CoRe]. The display
shows three selection options:
+
Settings: to configure the connection to the CoRe
server. The data to enter is as follows:
$
Host address: is the IP address of the CoRe
server.
$
Host port: is the server port used for the
connection, typically the port number is set to
59487 by default, but it is possible to check this
parameter on the CoRe server in the Settings -
Computer Overview section.
$
Password: is the password (Interface password)
set during the installation of the CoRe server.
5. Confirm the entered data with
"
ACS 653 will try to connect to the CoRe server to
check that all parameters entered are correct.
5.17.3

Operation

To use the CoRe function:
+
Select available A/C task: to select and perform
A/C services previously registered at CoRe server
level. After connecting the ACS 653 to the
CoRe server using the settings described above,
it is possible through this item to select one of
the available A/C services and perform it on the
desired vehicle. Once the A/C service is selected
and performed, the ACS 653 will send a report
to the CoRe server that will automatically save the
result and all data related to it.
+
Create new A/C task: to create an A/C service
from the ACS 653 and assign an Air Conditioning
Service to one of the active vehicles in the
workshop. Selecting this item will display the list of
all active vehicles in the workshop and registered
on the CoRe server regardless of whether or not
a specific A/C service has been requested. When
the vehicle is selected, the ACS 653 will send
a special command to the CoRe server so that
the latter registers that an A/C service is being
performed on the selected vehicle. At the end
of the A/C service, a detailed report will be sent
to the CoRe server that will save it and make it
available for displaying or printing.
Robert Bosch GmbH
6.
6.1
i
After selecting any service function, it is possible
to enter information about the vehicle in order to
allow printing the automatically compiled final
receipt.
1. The display shows
Enter vehicle data
Make: _________________________
Model: ________________________
Plate: ________________________
VIN: __________________________
MILEAGE: ______________________
Operator: _____________________
i
Use the arrow buttons to move between the rows
. and the multi touch keypad to enter the text.
2. Select
i
This page also shows the Database icon to allow
the user to select a vehicle from the European or
Personal Database if available. If this selection is
made, the BRAND and MODEL fields will be filled
out automatically.
!
Make sure to comply with the standards regarding
the protection of personal data in your state.
Initial settings | ACS 653 | 53 |

Instructions for use

Entering service data

to save the data for the print report.
1 689 989 618
en
|
2020-12-01