Assembling The Rc Unit - Carson PT-596 Betriebsanleitung

Assembling the RC unit

An appropriate RC unit must be
in service before you can take
your new model boat onto the
water. We recommend our 2.4
GHz transmitter tray unit CAR-
SON FS 6K REFLEx STICK 2 Article
no.: 500501006 which has been
used here as an example in the
following steps. You can achieve
a maximum range of approx. 100
metres with the FS 6K REFLEx
STICK 2.
Place your model boat on the pre-assembled boat stand (adhesive completely cured) and stay well clear of the propellers at all times. Carefully
remove the model's cover and have your receiver, RC unit and a fully charged driving battery ready. Now insert the receiver plug of the MARINE
speed controller into the throttle channel connection on the receiver. For the REFLEx STICK 2, the plug must be inserted into channel 1. Insert
the plug of the steering servo into the connection for channel 2 (for REFLEx STICK 2) on the receiver. For further information, refer to the Opera-
ting Instructions supplied with your remote control.
Pay attention also to the notes and information included in the instructions supplied for the speed controller.
connect the speed controller, motor, receiver and battery as shown in the diagram below:
to the battery
on/off switch
APProx. 100 M rANGe
Art. no.: 500501006
black
to the receiver
(Channel 1)
CARSON RC Premium Boat PT-596 500106004
red
steering servo
(Channel 2)
electric motor
G
19