Turn On The Rc System; Binding The 2.4 Ghz Rc Unit - Carson Mountain Warrior Sport Betriebsanleitung

turn on tHe rc SyStem

cAuTIoN!
Always turn the transmitter´s
power switch oN first!
To switch on the transmitter, press the power button until
the LED lights up.
To switch off, press the power button again until the LED
goes out.
1 Connect the rechargeable battery for the driving.
2 Switch on the receiver.
3 Put the body on and fix it with the body split pins.

bInDIng tHe 2.4 gHZ rc unIt

Modern 2.4 GHz units no longer require quartz crystals, so they're
completely interference free.
The transmitter may occasionally lose its connection to the model.
Should this happen, please take the following steps:
Binding cable
1
3
1 Switch off the transmitter and vehicle.
2 Keep the „right" button (steering trim) on the top of the transmit-
ter pressed down whilst switching on the transmitter. The blue
status LED starts to flash.
3 Now plug the binding cable supplied into the servo socket and
switch on the receiver. The binding process is now complete. Now
remove the binding cable and replace it with the servo cable.
4 Switch the receiver and transmitter off and then on again.
Servo cable
oN
17 // GB