Turn On The Rc System; Binding The 2.4 Ghz Rc Unit - Carson Beetle Warrior Bedienungsanleitung

turn on tHe rc SyStem

cAuTIoN!
Always turn the transmitter´s
power switch oN first!
To switch on the transmitter, press the power button until
the LED lights up.
To switch off, press the power button again until the LED
goes out.
1 Connect the rechargeable battery for the driving.
2 Switch on the receiver.
3 Put the body on and fix it with the body split pins.

bInDIng tHe 2.4 gHZ rc unIt

The modern 2.4 GHz system requires no more crystals and is comple-
tely Insensitive to interference.
Occasionally, it may be that lose the connection of model to the
transmitter.
Meets this happens, you must observe the following steps:
Binding cable
GB // 18
1
3
1 Turn off the transmitter and car.
2 Hold CH3 button pressed on the transmitter and turn on the
transmitter at same time. The blue LED will start to congestion
flash.
3 Now turn the receiver on the vehicle. The binding process is
complete.
4 Turn off the receiver and the transmitter and switch on again.
Now you can operate.
Servo cable
oN