Cleaning And Care - Vitek VT-2539 CL Die Betriebsanweisung

BEFORE USING THE UNIT
FOR THE FIRST TIME
After unit transportation or stor-
age at low temperature keep it
for at least three hours at room
temperature before switching on.
•
•
•
USAGE
To get the best results, wash your
hair with shampoo, wipe it with a dry
towel, dry with a hairdryer and comb
your hair. After that you can start styl-
ing your hair.
•
•
•
•
•
•
•
VT-2539.indd 5
Unpack the unit and remove any
stickers that can prevent unit oper-
ation.
Check the unit for damages, do
not use it in case of damages.
Before switching the unit on,
make sure that the voltage of the
mains corresponds to the unit
operating voltage.
Divide the hair into locks 4-5 cm wide.
Insert the power plug into the
mains socket.
Set the ON/OFF button (2) to the
«ON» position, the power indica-
tor (3) will light up.
Put the unit on the safety stand
(7) on a flat heat-resistant surface
and let it heat up.
Take a hair lock with the free hand.
Press the clamp handle (4),
place the end of the lock on the
operating surface (5) and move
the clamp down. Wind the lock
around the operating surface.
Wait for a while, then press the clamp
handle (4) and release the hair
lock.
•
Repeat this procedure on the rest
of your hair.
Note:
–
Do not touch the operating sur-
face during the unit operation.
–
During the first operation some
foreign smell and a small amount
of smoke from the operating sur-
face is possible, this is normal.
–
During breaks in operation, place
the unit on a flat heat-resistant
surface.
–
Do not comb your hair right after
styling, let it cool off. Divide big
locks into smaller ones carefully
to make the hairstyle look natural.
•
After you finish curling, switch the
unit off by setting the ON/OFF
button (2) to the «OFF» position,
the indicator (3) will go out.
•
Unplug the unit.
•
Put the unit on the safety stand (7)
and let it cool down completely.

CLEANING AND CARE

•
Before cleaning unplug the unit
and let it cool down completely.
•
Do not immerse the unit, the
power cord and the power plug
into water or any other liquids.
•
Do not use detergents, abrasives,
and any solvents to clean the unit.
•
Clean the unit body with a soft,
slightly damp cloth and then wipe
it dry.
STORAGE
•
Let the unit cool down completely
and clean it before taking away
for storage.
5
ENGLISH
19.01.2016 14:38:32