Cleaning And Care - Vitek VT-2507 GD Betriebsanweisung

•
Press the button (3) «
tom heating temperature indicator
(5) will start blinking (+120°С).
•
Use the buttons (4) «▲/▼» to set
the operating surface (7) tempera-
ture from +120°С to +200°С.
Note: Each indicator shows a certain
operating surface heating temperature:
+120°С, +140°С, +160°С, +180°С and
+200°С.
HAIR TYPE
Fine hair, sensitive
to high temperature
Normal wavy hair of
medium thickness
Hard, thick, curly
hair
Note: While setting the temperature,
remember that the operating surface
heats up fast but cools down much
longer.
•
Place the unit on the safety stand (9)
on a flat heat-resistant surface.
•
Once the operating surface (7)
reaches the set temperature, the
indicator (5) will glow constantly.
•
Take a hair lock with the free hand.
•
Press the clamp handle (6), place
the end of the lock on the operat-
ing surface (7) and move the clamp
down. Wind the lock around the
operating surface.
•
Wait for a while, then press the clamp
handle (6) and release the hair lock.
•
Repeat this procedure on the rest
of your hair.
Note:
–
Do not touch the operating surface
during the unit operation.
VT-2507.indd 5
–
», the bot-
–
–
•
TEMPERATURE
from +120
to +160°С
•
from +160
to +180°С
from +180

CLEANING AND CARE

to +200°С
•
•
•
•
STORAGE
•
•
•
•
5
ENGLISH
During the first operation some for-
eign smell and a small amount of
smoke from the operating surface is
possible, this is normal.
During the breaks between opera-
tions, place the unit on a flat heat-
resistant surface.
Do not comb your hair right after
styling, let it cool off. Divide big
locks into smaller ones carefully to
make the hairstyle look naturally.
After styling, switch the unit off by
pressing the button (3) «
then unplug it.
Put the unit on the safety stand (9)
on a flat heat-resistant surface and
let it cool down completely.
Before cleaning, unplug the unit and
let it cool down completely.
Do not immerse the unit, the power
cord and the power plug into water
or any other liquids.
Do not use detergents, abrasives
and any solvents to clean the unit.
Clean the unit body with a soft,
slightly damp cloth and then wipe
it dry.
Let the unit cool down completely
and clean it before taking away for
storage.
Do not wind the power cord around
the unit body as this can damage
the cord.
Keep the unit in a dry cool place out
of reach of children and disabled
persons.
You can store the unit by hanging
it by the loop (1) provided that no
water gets on it in this position.
», and
09.12.2014 17:48:40