Maintenance; Maintenance And Servicing Plan; Table Of Measures; Changing The Exciter Oil - Zipper Maschinen ZI-RPE330G Betriebsanleitung

17

MAINTENANCE

Hot surfaces and rotating machine parts while the engine is running can cause
serious injury or even death. Always stop the machine before carrying out any
conversion, adjustment, cleaning or maintenance work and secure it against
unintentional restarting.
17.1

Maintenance and Servicing Plan

17.1.1 Table of Measures

What to do?
Check fuel level
Check engine oil level
Control of the operating elements
Check for damaged parts
Checking for loose or lost screws
Change engine oil
Check V-belt
Change exciter oil
Air filter cleaning
Spark plug test
The specified intervals refer to working under "normal" operating conditions. Depending on the load,
a change/exchange may also be necessary at an earlier point in time.
17.2

Changing the exciter oil

17.2.1 Exciter oil check / change

ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-RPE330G
W A R N I N G
N O T I C E
Waste oils are toxic and must not be released into the environment!
Contact your local authorities for information on proper disposal.
Check
1. place the machine horizontally
2. open the cover to get access to the exciter
3. open the oil filler plug (1).
4. check the oil level. Oil should reach to the start of the
thread of the filling hole.
5. top up exciter oil if necessary
6. mount and tighten the oil filler plug (1).
7. Re-assemble the cover.
Change
1. open oil filler plug (1) and oil drain plug (2).
2. tilt the machine and keep it tilted until the oil has run
out. Collect oil in a suitable container!
3. place the machine horizontally and fit and tighten the
oil drain plug (2).
4. fill in exciter oil through the oil filling hole.
Fit oil filler plug (1) and tighten securely.
Frequency
before each start-up
before each start-up
before each start-up
before each start-up
before each start-up
After first 20h, then every 100h
every 50 h; replacement after 300 h or 1 year
After first 50h, then every 200h
every 50 h, replacement after 300 h or 1 year
every 100 h; replacement after 300 h or 1year
MAINTENANCE
29