Check Scope Of Delivery; Assembly; Checklist Before Each Use; Checking The Engine Oil Level - Zipper Maschinen ZI-RPE330G Betriebsanleitung

A safety note designed in this way indicates a potentially dangerous situation which, if
not avoided, may result in property damage.
Irrespective of all safety regulations, their sound common sense and corresponding technical
suitability/training are and remain the most important safety factor in the error-free operation of the
machine. Safe working depends first and foremost on you!
15

ASSEMBLY

15.1

Check scope of delivery

After delivery, check the machine immediately for transport damage and missing
Parts.
15.2 Assembly
The machine is delivered pre-assembled, only the plate extension can be
assembled with the supplied screws or the transport wheel, which is suitable for
transport over short distances, can be fixed in the hole of the base plate as shown.
15.1

Checklist before each use

The use of paint thinners, petrol, aggressive chemicals or abrasives leads to
material damage to the surfaces! Therefore use only mild detergents for cleaning!
Clean the machine and remove dirt and dust if necessary.

If the air filter is dirty, blow the filter cartridge from the inside by moving a jet of dry

compressed air up and down. Continue until all dust has been removed. Replace the
air filter with a new one if necessary.
Check the carburettor for external dirt and dust and clean it with dry compressed air if

necessary.
Check the nuts and bolts for tightness. (Screws or bolts loosened by vibrations can

lead to accidents!)

15.1.1 Checking the engine oil level

Too low oil level will damage the engine and shorten the life of the machine.
Therefore, check the engine oil level before every start and top up the engine oil if
necessary.
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-RPE330G
N O T I C E
N O T I C E
N O T I C E
1. To check the engine oil level, place the machine on a
safe, level surface. Switch off the engine and allow the
machine to stand for ten minutes so that the circulating
oil can collect in the oil pan.
2. Unscrew the oil dipstick and wipe with a clean, lint-free
cloth or a non-fibrous paper towel.
3. Push the dipstick into the opening, but do not screw it in.
(Make sure that the dipstick has really been pushed in
completely).
ASSEMBLY
25