Special Safety Instructions For That Machine; Safety Instructions For Machines With Combustion Engine - Zipper Maschinen ZI-RPE330G Betriebsanleitung

 Check that the machine is in perfect condition before each use. Ensure that all guards are in place
and working properly and that all nuts, bolts, etc. are securely tightened. Do not take the
machine into operation if you notice that parts are missing or damaged!
 Ensure sufficient lighting conditions in the working and surrounding areas of the machine.
 Keep hands and feet away from moving machine parts and always ensure a safe stand when
working.
 Ensure that the area to be tamped does not contain any electric cables, gas or water lines which
could be damaged by vibration.
 Remove the adjustment tool from the machine before operation.
 Never leave the running machine unattended (always stop the machine before leaving it).
 Ensure that unauthorised persons maintain a safe distance from the machine and keep children
away from the machine.
 The machine may only be operated, serviced or repaired by persons who are familiar with it and
who have been informed of the dangers arising during this work.
 Always wear suitable personal protective equipment (ear protection, gloves, safety shoes, close-
fitting protective clothing, etc.)!
 Do not work with the machine if you are tired, not concentrated or under the influence of
medication, alcohol or drugs!
 Never operate the unit in the presence of flammable liquids or gases (danger of explosion!).
 Carry out maintenance, adjustment and cleaning work only when the engine is switched off.
 Only use spare parts and accessories recommended by Zipper machines.
14.4

Special safety instructions for that machine

 The machine is designed to be operated by one person. Always operate the machine from behind.
Never stand next to or in front of the machine when the engine is running.
 Longer continuous use of the vibratory plate can lead to circulatory disturbances, especially of the
hands, caused by vibration. Therefore, take regular breaks from work!
 Wear suitable protective gloves to reduce the vibration intensity. The hardness of the surface to
be treated, personal predisposition to circulatory disorders and low outside temperatures
considerably reduce the permitted period of use.
 When working in or near excavations or building pits, make sure that the walls are stable and do
not run the risk of collapsing due to vibration.
 Keep away from edges and trenches and avoid situations where the vibratory plate could tip
over.
 Excessive noise can cause hearing damage and temporary or permanent hearing loss. Wear
hearing protection certified to health and safety regulations to limit noise exposure.
14.5

Safety instructions for machines with combustion engine

 Do not touch the engine and/or muffler during operation or immediately after switching off!
These areas become hot during operation and can cause burns.
 Do not touch the spark plug connector when the engine is running (electric shock!).
 Do not operate the unit in closed areas or in poorly ventilated rooms unless there is adequate
ventilation through exhaust fans or hoses. (Risk of suffocation from carbon monoxide!)
 Do not smoke while the machine is in operation.
 Do not smoke when refuelling the machine.
 Refuel the machine only in a well ventilated area.
 Do not refuel the machine when the engine is running or the machine is still hot.
 Do not refuel the machine near naked flames.
 Do not spill fuel when refuelling.
 Do not crank a gas flooded engine as long as the spark plug is removed- fuel in the cylinder
sprays out of the spark plug opening.
 Do not carry out an ignition spark test on engines if the engine is flooded or gas can be smelled.
A stray spark could ignite the vapours.
 Do not use fuel to clean machine parts, especially indoors. Vapours from fuels may explode.
 Always keep the area around the muffler free of foreign substances such as leaves, paper,
cardboard, etc. A hot muffler could ignite these substances and cause a fire.
 Close the filler cap after refuelling.
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-RPE330G
SAFETY
23