Stopping The Machine; In Emergency Situation; Normal Switch-Off; Moving The Machine Forwards / Backwards - Zipper Maschinen ZI-RPE330G Betriebsanleitung

16.4

Stopping the machine

16.4.1 In Emergency situation

In the case of danger and/or in an emergency situation, set the throttle to the lowest
position and the ignition switch to the OFF position immediately.

16.4.2 Normal switch-off

1. Set the upper throttle lever to "minimum" and let the engine run idle for approx. 3
minutes at low engine speed.
2. Then set the engine ON/OFF switch (ignition switch) to the OFF position.
3. Close the fuel tap.
4. Wait until the engine has cooled down before storing the machine.
16.5

Moving the machine forwards / backwards

ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-RPE330G
2. Set the engine
position
Note: The closed position of the choke lever enriches the fuel
mixture for starting a cold engine. The open position provides the
correct fuel mixture for normal operation after starting and for
restarting a warm engine.
3. Turn the choke lever to the "Closed" position, only for cold
engine.
4. Set the throttle lever to "half throttle" (= middle position
between "fast" and "slow").
Note: Do not pull the starter rope through to the end and do not
let it rewind after pulling, but only rewind it quickly.
5. Grab the starter handle and pull it out slowly. The resistance
becomes strongest at a certain point. This point corresponds to the
compression point. Let the rope roll back a little from this point and
then pull it out powerfully.
6. Turn the choke lever to "Open when the engine is running.
7. Open throttle further machine will start compacting.
Forward (F): Push directional lever forward
Reverse (R): Push directional lever forward
/ switch (ignition switch) also to the "On"
ON OFF
OPERATION
28