IKEA MEDELSTOR AA-2189660-3 Bedienungsanleitung Seite 19

ENGLISH
Activating options often increases
the water and energy
consumption as well as the
programme duration.
How to select and start the
programme AUTO
1. Press
• The light related to the button is on.
• The display shows the programme
duration.
Options are not applicable to this
programme.
2. Close the appliance door to start the
programme.
The appliance senses the type of load and
adjusts a suitable wash cycle. During the
cycle, the sensors operate several times and
the initial programme duration can
decrease.
How to delay the start of a
programme
1. Select a programme.
2. Press repeatedly until the display
shows the desired delay time (from 1 to
24 hours).
The light related to the button is on.
3. Close the appliance door to start the
countdown.
During the countdown, it is not possible to
change the delay time and the programme
selection.
When the countdown is complete, the
programme starts.
How to cancel the delay start while
the countdown operates
Press and hold for about 3 seconds.
The appliance returns to the programme
selection.
If you cancel the delay start, you
have to select the programme
again.
.
How to cancel a running programme
Press and hold for about 3 seconds.
The appliance returns to the programme
selection.
Make sure that there is detergent
in the detergent dispenser before
you start a new programme.
Opening the door while the
appliance operates
Opening the door while a programme is
running stops the appliance. It may affect
the energy consumption and the
programme duration. After closing the door,
the appliance continues from the point of
interruption.
If the door is opened for more
than 30 seconds during the
drying phase, the running
programme ends. It does not
happen if the door is opened by
AutoOpen function.
The Auto Off function
This function saves energy by switching the
appliance off when it is not operating.
The function activates automatically:
• After up to 15 seconds once the
programme is complete.
• After 5 minutes if a programme was not
started.
End of the programme
When the programme is complete, the
display shows 0:00.
The Auto Off function switches the appliance
off automatically.
All buttons are inactive except for the on/off
button.
19