Frequently Asked Questions - Motion CM-03 Gebrauchsanweisung

25 Activate / deactivate the motor
To prevent the blind from getting damaged, the motor has a transport
mode that makes sure the blind will not be activated before installation.
Hold the program button and pull twice to activate or deactivate the motor.
25.1
The motor can also be activated by charging it with a micro USB cable.

Frequently Asked Questions

Problem
Blind does not work.
Motor LED flashes red.
Blind is not charging.
Multiple blinds respond to a
remote. (Unable to program
a single blind)
Blind moves in small steps.
Favourite position can not
be programmed.
Blind lowers too far.
Blind moves in the opposite
direction.
The blind keeps moving up
and down.
M OT I ON C M- 03/0 5 LI - IO N T U B U LA R M O T O R
Cause
Motor is in transport mode.
Motor battery is empty.
Remote battery is empty. (LEDS of
remote are flashing rapidly.)
Remote battery is inserted
incorrectly.
Radio-frequency interference
The distance from the remote to
the motor is too far.
The remote is not connected to
the blind.
The battery of the motor is empty.
Charger is not plugged in or does
not work.
Multiple blinds are paired with a
single channel.
1) No end limits are programmed.
2) Direct control is deactivated.
No end limits are programmed.
End limits are programmed
incorrectly.
The rotational direction has been
set incorrectly.
The blind is in program mode.
Solution
Activate the motor. See step 25.
Charge the motor. See step 19.
Replace the battery in the remote.
See the manual of the remote.
Replace the battery in the remote.
See the manual of the remote.
Make sure that the antenna of the motor
is out of the way of metal objects.
Move closer to the motor.
Pair the remote with the motor.
See step 6.
Charge the motor. See step 19.
Try a different charger or make sure the
charger is plugged in the outlet.
Pair the blind with a free channel to
program or use single select to program
the blind.
1) Program end limits. See step 8 - 11.
2) Activate direct control. See step 17.
Program end limits.
See step 8 - 11.
Reprogram end limits. See step 8 - 11.
Change the rotational direction.
See step 7.
Press the program button on the motor
to exit program mode.