Frequently Asked Questions - Motion CM-04 Gebrauchsanweisung

Frequently Asked Questions

Problem
Blind does not work.
Multiple blinds respond to a
remote. (Unable to program a
single blind)
Blind moves in small steps.
Favourite position can not
be programmed.
Blind lowers too far.
Blind moves in the opposite
direction
The blind keeps moving up and
down.
M OT ION C M - 04 T U B U L AR M O TO R
Cause
Power supply is not connected or
the rechargeable battery is empty.
Remote battery is empty. (LEDS of remote
are flashing rapidly.)
Remote battery is inserted incorrectly.
Radio-frequency interference
The distance from the remote to
the motor is too far.
The remote is not connected to
the blind.
Multiple blinds are paired with a single
channel.
1) No end limits are programmed.
2) Direct control is deactivated.
No end limits are programmed.
End limits are programmed incorrectly.
The rotational direction has been
set incorrectly.
The blind is in program mode.
Solution
Connect the power supply to the motor
or charge the rechargeable battery tube.
Replace the battery in the remote.
See the manual of the remote.
Replace the battery in the remote.
See the manual of the remote.
Make sure that the antenna of the motor is
out of the way of metal objects.
Move closer to the motor.
Pair the remote with the motor.
See step 6.
Pair the blind with a free channel to
program or use single select to program
the blind.
1) Program end limits. See step 8 - 11.
2) Activate direct control. See step 17.
Program end limits . See step 8 - 11.
Reprogram end limits. See step 8 - 11.
Change the rotational direction.
See step 7
Press the program button on the motor
to exit program mode.