Connecting Wires To Terminals - Kenwood KDC-BT60U Kurzanleitung

Connecting Wires to Terminals

⁄
Do not remove the cap when you
do not use the USB cable. The
connector will cause the unit to
malfunction if it gets in touch with
any metallic part of the vehicle.
Connector Function Guide
Pin Numbers for
ISO Connectors
External Power
Connector
A-4
A-5
A-6
A-7
A-8
Speaker
Connector
B-1
B-2
B-3
B-4
B-5
B-6
B-7
B-8
8
Connector A
7
8
Connector B
7
12 | Quick Start Guide
Microphone
(Accessory3)
Cable Colour Functions
Yellow Battery
Blue/White Power Control
Orange/White Dimmer
Red Ignition (ACC)
Black Earth (Ground)
Connection
Purple Rear Right (+)
Purple/Black Rear Right (–)
Gray Front Right (+)
Gray/Black Front Right (–)
White Front Left (+)
White/Black Front Left (–)
Green Rear Left (+)
Green/Black Rear Left (–)
⁄
A–4 Pin (Yellow)
6 4 2
5 3 1 A–7 Pin (Red)
6 4 2
5 3 1
USB connector (1m)
To USB device
Microphone input (KDC-BT60U only)
See <Connecting the ISO Connector> (page 14).
⁄
• Speaker Impedance:
4 – 8 Ω
• USB terminal Maximum
Supply current
: 500 mA
Battery wire (Yellow)
Ignition wire (Red)