Accessories; Installation Procedure - Kenwood KDC-BT60U Kurzanleitung

Accessories

1
2
3
(KDC-BT60U only)
¤ CAUTION
• Keep battery out of reach of children
and in original package until ready to
use. Dispose of used batteries promptly.
If swallowed contact physician
immediately.
• Do not leave the battery near fire or
under direct sunlight. A fire, explosion
or excessive heat generation may result.
• Do not set the remote control in hot
places such as on the dashboard.
• Danger of explosion if Lithium battery is
incorrectly replaced. Replace only with
the same or equivalent type.
10 | Quick Start Guide

Installation Procedure

1. To prevent short circuits, remove the key
.....1
2. Make the proper input and output wire
3. Connect the wire on the wiring harness.
4. Take Connector B on the wiring harness
.....2
5. Take Connector A on the wiring harness
6. Connect the wiring harness connector to
.....1 (3m)
7. Install the unit in your car.
8. Reconnect the - terminal of the battery.
9. Press the reset button.
¤
Install this unit in the console of your
vehicle.
Do not touch the metal part of this unit
during and shortly after the use of the
unit. Metal part such as the heat sink and
enclosure become hot.
from the ignition and disconnect the -
terminal of the battery.
connections for each unit.
and connect it to the speaker connector
in your vehicle.
and connect it to the external power
connector on your vehicle.
the unit.
CAUTION