Connecting Wires To Terminals - Kenwood KDC-UI700RN Bedienungsanleitung

Connecting Wires to Terminals

USB connector
AUX input (Stereo)
Use the mini-plug cable which is stereo type
and does not have any resistance.
Front side
Fuse (10A)
Wiring harness
(Accessory1)
TEL mute wire (Brown)
If no connections are made, do not
let the wire come out from the tab.
Power control/ Motor antenna
control wire (Blue/White)
Battery wire (Yellow)
Ignition wire (Red)
⁄
A–7 Pin (Red)
A–4 Pin (Yellow)
Connector A
8 6 4 2
7 5 3 1
8 6 4 2
Connector B
7 5 3 1
FM/AM antenna input (JASO)
Rear output/ Sub Woofer output
To Kenwood disc changer/ External optional accessory
(KDC-W4544U/ W4644U only)
⁄
To connect these leads, refer to the relevant instruction manuals.
MUTE
P.CONT
ANT.CONT
See next page.
Connect to the terminal that is grounded when
either the telephone rings or during conversation.
⁄
To connect the Kenwood navigation system,
consult your navigation manual.
Connect either to the power control terminal
when using the optional power amplifier, or to the
antenna control terminal in the vehicle.
21
|
English