Installation The Microphone Unit - Kenwood KDC-BT60U Kurzanleitung

KDC-BT60U only

Installation the Microphone Unit

Removing the hard rubber frame
1. Check the installation position of the
microphone (accessory 3).
2. Remove oil and other dirt from the
installation surface.
3. Install the microphone.
4. Wire the cable up to the unit with it
secured at several positions using tape or
the like.
⁄
• Install the microphone as far as possible
from the cell-phone.
16 | Quick Start Guide
3
Accessory
Fix a cable with a commercial item of tape.
Peel the release coated paper of double-
face adhesive tape to fix on the place
shown above.
Adjust the direction of the microphone to
the driver.