Before First Use; Inserting The Rechargeable Battery Of The Robot Vacuum Cleaner; Assembling The Side Brushes - Philips FC9910 Handbuch

English
12
- You do not have to worry when the robot vacuum cleaner appears
to skip an area in auto cleaning or climb cleaning mode. It will use the
map stored in its memory to return to this area later.
- You can use the timer to set the time at which you want the robot
vacuum cleaner to start cleaning. The robot vacuum cleaner will start
cleaning in auto cleaning mode at the set time. When it has finished
cleaning, it will return to the base station to charge.
- If you do not press any of the buttons on the robot vacuum cleaner or
on the remote control for 5 minutes when the robot vacuum cleaner
is in operational mode but is not cleaning in any of the cleaning modes,
the appliance automatically switches to standby mode.

Before first use

inserting the rechargeable battery of the robot vacuum cleaner

The rechargeable battery is supplied separately and needs to be
inserted before use.
1 Place the appliance upside down on a soft, flat surface.
2 Align the latches on the sides of the rechargeable battery with the
recesses in the side of the battery compartment and insert the
battery. Press the battery home until it locks into place ('click').
Note: If the battery is empty, you have to charge the robot vacuum cleaner
before you can use it.

assembling the side brushes

1 Unpack the side brushes.
2 Align the holes in the centre of the side brush marked with an L with
the half-round mounting pin with an L on the bottom of the robot
vacuum cleaner and push the side brush home.
3 Align the holes in the centre of the side brush marked with an R
with the half-round mounting pin with an R on the bottom of the
robot vacuum cleaner and push the side brush home.