Panasonic WH-ADC1216H6E5 Installationshandbuch Seite 9

Remove The Remote Controller From Tank Unit
1. Remove the top case from the bottom case.
2. Remove the wiring between Remote controller and Tank Unit
terminal.
Claw
(2 places)
Disconnect the
Remote controller
wiring
Mounting The Remote Controller
For exposed type
Preparation: Make 2 holes for screws using a driver.
Mount the top case.
•
Align the claws of the top
case and then align the claws
of the bottom case.
Cut here with
a nipper and
remove the burr
with a fi le.
Claw (2 places)
Screw
(fi eld supply)
Connect the remote control
wiring
•
Arrange the wires along the groove
of the case.
Top case
(Back side)
Bottom case
(Back side)
Insert the
driver and
slightly turn.
Flat-blade
screwdriver
Bottom
case
Mount the bottom case to
the wall.
U P
Wall to which
the remote
controller is
fi xed
Hole for screw
Claw (2 places)
Clamper
(fi eld supply)
Pass through
the hole
Remote controller terminal board
Remove the coating. Approx. 6 mm
Remove the sheath. Approx. 180 mm.
Make sure the wiring connection is in the
correct direction.
For embedded type
Preparation: Make 2 holes for screws using a driver.
Mount the top case.
•
Align the claws of the top
case and then align the claws
of the bottom case.
Avoid the wire
being caught.
Claw (2 places)
Screw
(fi eld supply)
Connect the remote
control wiring
Bottom case
(Back side)
Replace The Remote Controller Cover
•
Replace the existing Remote controller cover with Remote controller
cover 4 to close the hole left after remove the Remote controller.
1. Release the Remote controller cover's hooks from behind the
Front Plate e.
e
Front Plate
Existing Remote
controller cover
Mount the bottom case
to the wall.
•
Pass the wire through the hole
in the centre of the bottom case.
U P
Hole for
screw
Claw (2 places)
Remote controller
terminal board
Remove the coating.
Top case
Approx. 6 mm
(Back side)
Make sure the wiring
connection is in the correct
direction.
Hook (6 places)
9