Mounting To The Bike Frame; Use; Maintenance And Storage - Crivit IAN 278519 Gebrauchsanweisung

• There is a risk of explosion with over-inflated tyres!
• The pressure must be controlled using a calibrated
measurement device.

Mounting to the bike frame

• Remove the screws from the frame designed for
attaching a drinking bottle (fig. B).
• Attach the bike mount (4) to the frame with the
included screws (6) or the screws from the drin-
king bottle mount (fig. C).
• Secure the pump by placing the rubber ring (3)
around the pump (fig. D).
• If the included screws are too large or
too small, please purchase the correct
screws from a specialist retailer.
Always ensure the article is attached
securely and tightly! The bike mount
must stay secure even on unpaved sur-
faces and it must not wobble.
Otherwise there is a risk of losing the
bike mount with the mini air pump.

Use

• Open the top cap (2) and remove the hose (7).
• Open the bottom cap (5). Depending on whether
you have a Schrader valve (8), Dunlop valve (9),
or Sclaverand valve (9), screw the correct end of
the hose to the other end of the mini air pump
(see label on the hose: Schrader/Dunlop, Sclave-
rand) (fig. E).
• Open the cap on the tyre valve.
• Screw the correct end of the hose to the OPEN
valve and then pump (fig. F).
Special note when pumping bike tyres using the
Sclaverand valve (9):
1. Remove the knurled nut (on the bike valve casing)
of the bike valve.
2. Place the Sclaverand valve vertically on the bike
valve, then pump.
3. Now tighten the knurled nut on the bike valve
again after pumping.
• Caution! The hose on the mini air pump
must not be bent!
• Pump the mini air pump in a regular motion and
do not pump too fast.
When the article is not in use, please always store
the hose inside the mini air pump.
Close the caps securely, and always put the mini air
pump in the mount with the handle of the air pump
pointing upward.

Maintenance and storage

Never submerge the pump in water as this will da-
mage the article. Always store the article in a clean,
dry, temperature-controlled room. Important!
Only clean with a damp cloth and then wipe dry.
GB/MT 17