DeWalt DW040 Bedienungsanleitung Seite 53

• If your LDM requires repair, contact your local D
center.
• When the LDM is not in use, store it in the pouch provided.
• Do not store your LDM in the pouch if it is wet. Dry exterior parts
with a soft, dry cloth and allow the LDM to air dry.
• Do not store your LDM at temperatures below –7 ˚C (20 ˚F) or
above 70 ˚C (160 ˚F).
CAUTION: Never use solvents or other harsh chemicals
for cleaning the non-metallic parts of the laser. These
chemicals may weaken the materials used in these parts.
Use a cloth dampened only with water and mild soap.
Never let any liquid get inside the unit; never immerse any
part of the unit into a liquid. Never use compressed air to
clean the laser.
Field Calibration Check
Measure a known distance [within a 3–10 m (10–30') range] with the
LDM to confirm that the LDM is functioning properly.
Laser Accessories
Recommended accessories for use with your LDM are available at
extra cost from your local service center.
WARNING: Since accessories, other than those offered
by D WALT, have not been tested with this product, use
E
of such accessories with this tool could be hazardous.
To reduce the risk of injury, only D
accessories should be used with this product.
If you need assistance in locating any accessory, please contact your
local D WALT authorised service center.
E
DANGER: To reduce the risk of serious personal injury,
never stare directly into the laser beam, with or without
safety glasses.
E NGLI SH
WALT service
E
WALT, recommended
E
51