Operation - DeWalt DW040 Bedienungsanleitung

Installing and Removing Battery (fi g. 1, 3)
NOTE: This LDM is powered by two LR03 (AAA-size) 1.5 V
INSTALLING THE BATTERY PACK
1. Lift up the battery compartment cover (a) as shown in figure 1.
2. Insert two LR03 (AAA-size) batteries into the compartment, placing
the batteries according to + and – icons on the inside of the
compartment.
NOTE: When the battery indicator (o) flashes in the LCD, the batteries
are nearing the end of usable life.
Attachment of Wrist Strap (fi g. 2)
Refer to figure 2 for instructions.

OPERATION

WARNING! Do not place the laser in a position which
may cause anyone to intentionally or unintentionally
stare into the laser beam. Serious eye injury may result
from staring at the beam.
Instructions for Use
WARNING: Always observe the safety instructions and
applicable regulations.
CAUTION: Use of controls or adjustments or performance
of procedures other than those specified herein may result
in hazardous radiation exposure.
CAUTION: To reduce the risk of personal injury or property
damage and to ensure consistent, high-quality readings,
control measurements should be performed periodically
and before and after important measurements. Refer to
Field Calibration Check under Maintenance.
IMPORTANT NOTE: All measurements are relative to the base of the
LDM (fig. 4).
E NGLI SH
batteries.
DC
47