Order the carbon filter from your dealer or in our
online accessories shop, www.bomann-germany.de.
Use the reference number found under
Data".
"Installing the activated carbon filter for recir-
See
culation mode".
Remove and dispose the old carbon filter.
Replacing the bulb
CAUTION:
Do NOT remove the LED lighting cover!
The bulb may only be replaced by an authorized
specialist in case of a defect.
WARNING:
LED light is very bright and can damage the eyes.
Never look directly into the LED light!
Disconnect the appliance from the power supply
and allow the lamps to cool down before changing
the lamp. There is a risk of burns!
NOTE:
Order the lamps from your dealer or in our online
accessories shop www.bomann-germany.de.
Lamp data: LED max. 1 x 2.0W, AC 12V,
ILCOS D Code after EN 61231: DBS-2/30-H-120-33
Remove the grease filter.
or (b):
Open the black protective box of the plug-in
device and release the plug connection.
Carefully push the lamp out of the holder.
"Technical
Depending on model (a)
Replace defect LED module and connect the two
ends of the plug-in device.
Insert new lamp properly in the bulb holder.
Close the protective box with inserted plug-in
device. Replace the grease filter.
Troubleshooting
Before you contact an authorized specialist
Problem
Possible Cause / Solution
Unit is not
∙ Check the power supply.
working or
∙ Check the power level.
not properly
Unit is not
∙ Check the power level. ∙ Is the
working
kitchen properly ventilated?
efficiently
∙ Clean the grease filter. ∙ At re-
circulation mode, check the car-
bon filter. ∙ Check the air outlet.
Light is not
∙ Check the bulb, see
working
the bulb".
Oil is drip-
∙ Clean the grease filter.
ping
NOTE:
If you are still having problems after following steps
above, contact your trader or an authorized techni-
cian.
Technical Data
Electrical connection............................................
Connection voltage: ..................220-240 V~ / 50 Hz
Connection power: ........................................67 W
Lighting, LED: .......................................1 x 2.0 W
Protection class: ...............................................I
Weight / Dimensions in mm...................................
Net weight: ......................................approx. 7.0 kg
22
"Replacing