Appliance Equipment; Installation - BOMANN DU 652.1 IX Bedienungsanleitung, Garantie

Appliance Equipment

Appliance overview
Delivery scope
2x aluminum grease filter, 1x 2-part chimney shaft,
1x exhaust hose, 2x non-return valve,
tion material and drilling template
This product contains a light source of energy effi-
ciency class G.

Installation

The cooker hood is only intended to be installed
over a hob with no more than four hob elements
There must be a safety distance between the hot-
plate of the cooking pot on the hob and the bottom
part of the cooker hood:
The distance must be between 65 – 75 cm. For gas
appliances, the distance must be at least 65 cm. If
the installation instructions for the gas cooker specify
a greater distance, this distance must be taken into
consideration.
Selecting the fume outlet
You can operate the cooker hood in two modes:
1 Aluminum grease filter
2 Motor unit
3 Unit housing
4 Shaft
incl. Installa-
Extraction mode
WARNING:
 The extracted air may not be vented into a flue
which is used for the waste gas from appliances
which are powered by gas or other fuels.
 When venting the extracted air, comply with the
regulations of the relevant local authorities.
The hood has an upper air outlet to vent cooking
odors to the outside.
Recirculation mode
If you do not have a direct extraction vent to the out-
.
side; the hood can also work in recirculation mode
(i.e. without an extraction vent to the outside; the
filtered air is released back into the room). In this
case, activated carbon filter as described under
stalling the activated carbon filter for recirculation
mode"
, must be used.
Activated carbon filter are not supplied. You can or-
der the carbon filter from your dealer or in our online
accessories shop, www.bomann-germany.de. To
order, use the reference number found under
nical Data".
Assembly
WARNING:
 When assembling or inserting the extraction filter
as well as the carbon filter, the appliance must not
be connected to the mains.
18
The extracted air is normally
vented vertically. The extracted
air can vented through the wall
units and the loft floor to the roof
ridge.
If there is a conduit under the
wall units, the extraction duct can
be routed so that the extracted
air can be vented horizontally
through the wall.
"In-
"Tech-