Startup / Operation - BOMANN DU 652.1 IX Bedienungsanleitung, Garantie

 Secure the housing with the screws
2x ST4*30mm through the housing
 Fix the outer (lower) shaft with the bracket (03)
using the self-tapping screws 2x ST4*8mm
(Fig. 5).
For extraction mode:
the exhaust hose and connect it with the outlet open-
ing.
 Put on the telescoped shaft unit and fasten the
shaft middle bracket (03) with the screws
(Fig. 6).
2x ST4*40mm
 Pull up the inner shaft and fix the shaft cover lat-
erally to the shaft closure bracket (02) using the
self-tapping screws 2x ST4*8mm
Installing the activated carbon filter for recirculation
mode
 Remove the aluminum grease filter (see
ing the aluminum grease filter"
 Place the carbon filter onto the air
intake of the extraction duct.
Make sure that the mounting pins
on the extraction duct engage the mounting slots
of the carbon filter. Turn the filter clockwise until it
clicks into place.
 Reinstall the aluminum grease filter.
Electrical connection
WARNING:
 The installation to the mains supply must conform
to the local standards and regulations.
 Improper connection may cause to an electric
shock!
 Do not modify the appliance plug. If the plug does
not fit properly to the outlet, let install a proper
outlet by an authorized specialist.
 The accessibility of the power plug must be en-
sured to disconnect the appliance from the power
supply in case of emergency.
(Fig. 4)
Check the correct position of
(Fig. 7)
).
 Ensure that your mains power corresponds with
. the specifications of the appliance. The specifica-
tions are printed on the rating label.
 Connect the mains cable to a properly installed
and earthed wall outlet.
 If the plug after installation is not accessible, a
corresponding disconnect device must be availa-
ble to meet the relevant safety regulations.
The hood is to operate via two slide switches. The
lighting as well as the fan settings must be switched
on and off with the corresponding switches.
.
Power level
0 off
Lighting
"Clean-
0 lighting off
Settings
I Power level:
Suitable for cooking on a low flame and for dishes
which produce no or little steam, in order to circulate
the air around the kitchen.
II Power level:
Suitable for normal cooking.
III Power level:
Suitable if large quantities of smoke and steam need
to be extracted or filtered (e. g. when frying).
NOTE:
With very strong vapor emission, the fan should con-
tinue running after cooking for a few minutes.
20

Startup / Operation

I low II medium
I lighting on
III high