Troubleshooting; Technical Data - BOMANN DU 7603 G Bedienungsanleitung, Garantie

 Remove the grease filter. Carefully push the lamp
out of the holder through the housing; pull out the
lamp and release the plug connection.
 Replace defect LED module and pin the two ends
of the plug-in device.
 Insert new lamp properly in the bulb holder. Re-
place the grease filter.
Light stripes (ambient lighting)
Lamp data: LED max. 2 x 6W, DC 12V,
Length 275 mm
 Open the protective box below the glass cover
and loosen the light strip holder with a screwdriv-
er. Release the plug connection.
 Replace defect LED module and pin the two ends
of the plug-in device.
 Insert new light strip properly in the stripe holder.
Close the protective box with inserted plug con-
nection and secure the light strip holder.

Troubleshooting

Before you contact an authorized specialist
Problem Possible Cause / Solution
Unit is not
∙ Check the power supply.
working or
∙ Check the power level.
not properly
Unit is not
∙ Check the power level. ∙ Is the
working
kitchen properly ventilated?
efficiently
∙ Clean the grease filter. ∙ At re-
circulation mode, check the car-
bon filter. ∙ Check the air outlet.
Light is not
∙ Check the bulb, see
working the bulb".
Problem
Oil is drip-
ping
NOTE:
If you are still having problems after following steps
above, contact your trader or an authorized techni-
cian.
Electrical connection............................................
Connection voltage: ..................220-240 V~ / 50 Hz
Connection power: ......................................245 W
Lighting, LED: .......................................2 x 1.5 W
Ambient lighting, LED: .................................2 x 6 W
Protection class: ...............................................I
Weight / Dimension in mm.....................................
Net weight: ...................................approx. 16.0 kg
Available accessory............................................
Activated carbon filter for recirculation mode: ...........
KF 561 (Art.-No. 256 100)
The right to make technical and design modifications
during continuous product development remains
reserved.
This appliance has been tested according to all rele-
vant current CE guidelines, such as electromagnetic
"Replacing
compatibility and low voltage directives, and has
24
Possible Cause / Solution
∙ Clean the grease filter.

Technical Data

not supplied