Replacing the bulb
CAUTION:
Do NOT remove the LED lighting cover!
The bulb may only be replaced by an authorized
specialist in case of a defect.
WARNING:
LED light is very bright and can damage the eyes.
Never look directly into the LED light!
Disconnect the appliance from the power supply
and allow the lamps to cool down before changing
the lamp. There is a risk of burns!
NOTE:
Order the lamps from your dealer or in our online
accessories shop www.bomann-germany.de.
Lamp data: LED max. 2 x 1.5W, DC 12V,
ILCOS D Code after EN 61231: DSR-1.5/30-S-64
Open the glass cover via the Operation button
first and disconnect the power supply!
Remove the grease filter. Carefully push the lamp
out of the holder through the hood body; pull out
the lamp and release the plug connection.
Replace defect LED module and pin the two ends
of the plug-in device.
Insert new lamp properly in the bulb holder. Re-
place the grease filter.
Troubleshooting
Before you contact an authorized specialist
Problem
Possible Cause / Solution
Unit is not
∙ Check the power supply.
working or
∙ Check the power level.
not properly
Unit is not
∙ Check the power level. ∙ Is the
working
kitchen properly ventilated?
efficiently
∙ Clean the grease filter. ∙ At re-
circulation mode, check the car-
bon filter. ∙ Check the air outlet.
Light is not
∙ Check the bulb, see
working
the bulb".
Oil is drip-
∙ Clean the grease filter.
ping
NOTE:
If you are still having problems after following steps
above, contact your trader or an authorized techni-
cian.
Technical Data
Electrical connection............................................
Connection voltage: ..................220-240 V~ / 50 Hz
Connection power: ........................................73 W
Lighting, LED: .......................................2 x 1.5 W
Protection class: ...............................................I
Weight / Dimension H x W x D...............................
Net weight: ...................................approx. 17.0 kg
24
"Replacing