Troubleshooting - BOMANN DU 7602 G Bedienungsanleitung, Garantie

 Remove the aluminum grease filter by sliding
back the lock in the handle recess, push the filter
down gently and pull out towards the front.
 Rinse the grease filter in a solution of hot water
and neutral detergent. Soak the filter in it.
 Then clean with a soft brush, rinse thoroughly with
hot water and allow drying.
 Alternatively, the grease filter can also be cleaned
in the dishwasher (up to 65°C). Slight discolora-
tion may occur. This does not affect the function
of the grease filter.
Replacing the activated carbon filter
The activated carbon filter prevents odors and must
depend on the use but be changed at least every six
months.
Order the carbon filter from your dealer or in our
online accessories shop, www.bomann-germany.de.
Use the reference number found under
Data".
"Installing the activated carbon filter for recir-
 See
culation mode".
 Remove and dispose the old carbon filter.
Replacing the bulb
CAUTION:
Do NOT remove the LED lighting cover!
The bulb may only be replaced by an authorized
specialist in case of a defect.
WARNING:
 The LED light is very bright and can damage the
eyes. Never look directly into the LED light!
 Disconnect the appliance from the power supply
and allow the lamps to cool down before changing
the lamp. There is a risk of burns!
NOTE:
Order the lamps from your dealer or in our online
accessories shop www.bomann-germany.de.
Lamp data: LED max. 2 x 1.5 W, AC 220-240 V
 Remove the grease filter(s). Carefully push the
lamp out of the holder through the housing; pull
out the lamp and release the plug connection.
 Replace defect LED module and connect the two
ends of the plug-in device.
 Insert new lamp properly in the bulb holder. Re-
place the grease filter(s).
Before you contact an authorized specialist
Problem
"Technical
Unit is not
working or
not properly
Unit is not
working
efficiently
Light is not
working
Oil is drip-
ping
NOTE:
If you are still having problems after following steps
above, contact your trader or an authorized techni-
cian.
44

Troubleshooting

Possible Cause / Solution
- Check the power supply.
- Check the power level.
- Check the power level.
- Is the kitchen properly ventilat-
ed?
- Clean the grease filter(s).
- At recirculation mode, check the
carbon filter.
- Check the air outlet.
- Check the bulb, see
the bulb".
- Clean the grease filter(s).
"Replacing