BOMANN DU 652.1 IX Bedienungsanleitung, Garantie Seite 19

WARNING:
 Failure to use the mounting fixtures may lead to a
risk of electric shock.
CAUTION:
 Before mounting, check that the wall has enough
loading capacity to bear the cooker hood.
 When drilling the holes in the wall always make
sure that no existing electrical cables or other ob-
jects are damaged.
 Make sure that the ventilation slots are clear of
obstacles and are not covered.
NOTE: Recommendations for preparation work
 When installing, ask another person to assist.
 Wear protective gloves to prevent injuries from
any sharp edges.
01
Fig. 1
Fig. 2
Fig. 3
02 03
A Shaft closure bracket
B Shaft middle bracket
C Suspension housing
E Securing housing
Fig. 2a
Fig. 4
Fig. 5
Fig. 7
 Determine the position of the cooker hood central-
ly above the cooking area in accordance with the
specified safety distances.
Totally 9x mounting holes with a diameter of approx.
8 mm are necessary for the wall mounting. Insert the
(Fig. 1).
supplied dowels
 First, drill the holes for attaching the housing ac-
cording to the enclosed drilling template. Check
the markings with a spirit level first!
Fasten the bracket (01) for suspending the
-
housing with the 3x ST4*40mm screws.
 Fasten the bracket (02) for the shaft closure with
the screws 2x ST4*40mm after you have deter-
mined the extension length of the shaft cover.
 Before attaching the housing, insert the two non-
return valves by lightly bending them from above
into the connecting piece (extraction duct)
For extraction mode:
hose (supplied) with an inner diameter of 150 mm
(Fig. 2a).
must be attached
cable tie.
 Hang up the housing. Check the secure hold and
the horizontal position
19
Fig. 6
Hereupon a flexible exhaust
Secure the hose with a
(Fig. 3)
.
(Fig. 2).