Startup / Operation - BOMANN DU 7605 G Bedienungsanleitung, Garantie

For exhaust mode:
Hereupon a flexible exhaust hose
(included in delivery) with 150 mm inner diameter
must be attached. Secure the hose with the enclosed
cable tie [Fig. 2a].
 Hang up the housing. Check the secure hold and
the horizontal position. To secure the housing (D),
screw in the upper screws 2x ST4*30mm [Fig. 3].
 Fix the bracket (with angle) for the upper shaft
closure (A) with the screws 2x ST4*40mm; after
determining the extension length of the shaft cov-
er [Fig. 4].
For exhaust mode:
Check the correct position of the
exhaust hose and connect it with the outlet opening.
 Fasten the outer (lower) shaft with the bracket
(without angle) using the 2x ST4*8mm self-
tapping screws [Fig. 5].
 Put on the telescope shaft unit; fix the shaft unit
laterally to the housing with self-tapping screws 2x
ST4*8mm and fix the middle shaft bracket (B) with
the screws 2x ST4*40mm [Fig. 6].
Pull up the inner shaft and fix the shaft cover lat-
erally to the shaft closure bracket using self-
tapping screws 2x ST4*8mm [Fig. 6].
Installing the activated carbon filter for recirculation
mode
 Open the grease filter cover. Remove the alumi-
num grease filter(s) (see
grease filter"
).
 Place the carbon filter onto the air intake of the
extraction duct. Make sure that the mounting pins
on the extraction duct engage the mounting slots
of the carbon filter. Turn the filter clockwise until it
clicks into place.
"Cleaning the aluminum
 Reinstall the aluminum grease filter(s). Close the
cover.
Electrical connection
WARNING:
 The installation to the mains supply must conform
to the local standards and regulations.
 Improper connection may cause to an electric
shock!
 Do not modify the appliance plug. If the plug does
not fit properly to the outlet, let install a proper
outlet by an authorized specialist.
 The accessibility of the power plug must be en-
sured to disconnect the appliance from the power
supply in case of emergency.
 Ensure that your mains power corresponds with
the specifications of the appliance. The specifica-
tions are printed on the rating label.
 Connect the mains cable to a properly installed
and earthed wall outlet.
 If the plug after installation is not accessible, a
corresponding disconnect device must be availa-
ble to meet the relevant safety regulations.

Startup / Operation

Operation is partly possible in two ways:
via function buttons (touch control) and
-
via motion sensors
-
After connection to the power supply, all buttons and
the display light up for about 2 seconds, after that the
appliance switches to standby mode.
Function buttons / description
Button backlight
The button illumination indicates the activation of the
respective function button and goes out as soon as
the function button is deactivated.
45