Startup / Operation - BOMANN DU 7600 IX Bedienungsanleitung, Garantie

Installing the activated carbon filter for recirculation
mode
 Remove the aluminum grease filter (see
ing the aluminum grease filter"
 Place the carbon filter onto
the air intake of the extrac-
tion duct. Make sure that
the fixing pins of the carbon
filter engage in the fastening slots of the exhaust
air duct. Put the filter in A and press firmly flat B.
 Reinstall the aluminum grease filter.
Electrical connection
WARNING:
 The installation to the mains supply must conform
to the local standards and regulations.
 Improper connection may cause to an electric
shock!
 Do not modify the appliance plug. If the plug does
not fit properly to the outlet, let install a proper
outlet by an authorized specialist.
 The accessibility of the power plug must be en-
sured to disconnect the appliance from the power
supply in case of emergency.
 Ensure that your mains power corresponds with
the specifications of the appliance. The specifica-
tions are printed on the rating label.
 Connect the mains cable to a properly installed
and earthed wall outlet.
 If the plug after installation is not accessible, a
corresponding disconnect device must be availa-
ble to meet the relevant safety regulations.
"Clean-
).
20

Startup / Operation

The cooker hood is operated via push buttons:
Switch the operation off
Power level low
Power level medium
Power level high
Switch the lighting on / off
Settings
Low speed:
Suitable for cooking on a low flame and for dishes
which produce no or little steam to circulate the air
around the kitchen.
Medium speed:
Suitable for normal cooking.
High speed:
Suitable if large quantities of smoke and steam need
to be extracted or filtered (e. g. when frying).
NOTE:
With very strong vapor emission, the fan should con-
tinue running after cooking for a few minutes. Set the
delay time with automatic switch-off for this purpose.
Energy saving tips
Information to reduce the environmental effect of
cooking (acc. VO (EU) No. 66/2014 appendix I,
No. 2)
 The diameter of the pot and pan floors should be
according to the size of the cooking zone.
 Use pans and pots with flat floors, uneven floors
increase the energy consumption.
 Ensure that there is enough supply air for the oper-
ation of the cooker hood.
 Adjust the fan step intensity of the damp evolution
of the cooking process.
 To product the optimal effect of the cooker hood,
install it according to the installation instructions.