Declaration Of Conformity; Battery Charging - Bosch gbh 36 V-LI Professional Originalbetriebsanleitung

OBJ_BUCH-283-001.book Page 23 Monday, July 23, 2007 12:41 PM

Declaration of Conformity

We declare under our sole responsibility that
the product described under "Technical Data" is
in conformity with the following standards or
standardization documents: EN 60745 accord-
ing to the provisions of the directives
2004/108/EC, 98/37/EC (until Dec. 28, 2009),
2006/42/EC (from Dec. 29, 2009 on).
Technical file at:
Robert Bosch GmbH, PT/ESC,
D-70745 Leinfelden-Echterdingen
Dr. Egbert Schneider Dr. Eckerhard Strötgen
Senior Vice President Head of Product
Engineering Certification
12.07.2007, Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
Assembly

Battery Charging

Use only the battery chargers listed on the
accessories page. Only these battery charg-
ers are matched to the lithium ion battery of
your power tool.
Note: The battery is supplied partially charged.
To ensure full capacity of the battery, complete-
ly charge the battery in the battery charger be-
fore using your power tool for the first time.
The lithium ion battery can be charged at any
time without reducing its service life. Interrupt-
ing the charging procedure does not damage the
battery.
The Li-ion battery is protected against deep dis-
charging by the "Electronic Cell Protection
(ECP)". When the battery is empty, the machine
is switched off by means of a protective circuit:
The inserted tool no longer rotates.
Do not continue to press the
WARNING
On/Off switch after the machine
has been automatically switched off. The bat-
tery can be damaged.
Bosch Power Tools
Removing the Battery
The battery 16 is equipped with two locking lev-
els that should prevent the battery from falling
out when pushing the battery unlocking button
11 unintentionally. As long as the battery is in-
serted in the power tool, it is held in position by
means of a spring.
To remove the battery 16:
– Push the battery against the base of the pow-
er tool (1.) and at the same time press the
battery unlocking button 11 (2.).
– Pull the battery out of the power tool until a
red stripe becomes visible (3.).
– Press the battery unlocking button 11 again
and pull out the battery completely.
Battery Charge-control Indication
The three green LEDs of the battery charge-con-
trol indicator 14 indicate the charge condition of
the battery 16. For safety reasons, it is only pos-
sible to check the status of the charge condition
when the machine is at a standstill.
Push button 15 to indicate the charge condition
(also possible when the battery is removed).
The battery charge-control indicator automati-
cally goes out after approx. 5 seconds.
LED
Continuous lighting 3 x green ≥2/3
Continuous lighting 2 x green ≥1/3
Continuous lighting 1 x green <1/3
Flashing light 1 x green
When no LED lights up after pushing button 15,
then the battery is defective and must be re-
placed.
1 619 929 777 | (23.7.07)
English | 23
Capacity
Reserve