Starting Operation - Bosch gbh 36 V-LI Professional Originalbetriebsanleitung

OBJ_BUCH-283-001.book Page 26 Monday, July 23, 2007 12:41 PM
26 | English
Note: If the tool holder was opened to the stop,
then the latching noise possibly may be heard
while closing the tool holder and the tool holder
will not close.
In this case, turn the front sleeve 23 once in the
opposite direction of the arrow. Afterwards, the
tool holder can be closed (tightened) again.
Turn the mode selector switch 10 to the "drill-
ing" position.
Removing Drilling Tools without SDS-plus
(GBH 36 VF-LI) (see figure J)
Firmly hold the retaining ring 24 of the quick
change chuck. Open the tool holder by turning
the front sleeve 23 in the direction of the arrow
until the tool can be removed.
Dust Extraction with the Dust
Extraction Attachment (Accessory)
Mounting the Dust Extraction Attachment
(see figure K)
For dust extraction, the dust extraction attach-
ment (accessory) is required. When drilling, the
dust extraction attachment retracts so that the
attachment head is always close to the surface
at the drill hole.
Press the button for depth stop adjustment 12
and remove the depth stop 17. Press button 12
again and insert the dust extraction attachment
into the auxiliary handle 18 from the front.
Connect an extraction hose (diameter 19 mm,
accessory) to the extraction sleeve 25 of the
dust extraction attachment.
The vacuum cleaner must be suitable for the ma-
terial being worked.
When vacuuming dry dust that is especially det-
rimental to health or carcinogenic, use a special
vacuum cleaner.
Adjusting the Drilling Depth on the Dust
Extraction Attachment (see figure L)
The required drilling depth X can also be adjust-
ed when the dust extraction attachment is
mounted.
1 619 929 777 | (23.7.07)
Insert the SDS-plus drilling tool to the stop into
the SDS-plus tool holder 3. Otherwise, the mov-
ability of the SDS-plus drilling tool can lead to
incorrect adjustment of the drilling depth.
Loosen the wing bolt 29 on the dust extraction
attachment.
Without switching the power tool on, apply it
firmly to the drilling location. The SDS-plus drill-
ing tool must face against the surface.
Position the the guide pipe 30 of the dust ex-
traction attachment in its holding fixture in such
a manner that the head of the dust extraction at-
tachment faces against the surface to be drilled.
Do not slide the guide pipe 30 further over the
telescopic pipe 28 of the dust extraction attach-
ment than required, so that as much as possible
of the scale 28 on the telescopic pipe remains
visible.
Retighten the wing bolt 29 again. Loosen the
clamping screw 26 on the depth stop of the dust
extraction attachment.
Move the depth stop 27 on the telescopic pipe
28 in such a manner that the clearance X shown
in the figure corresponds with the required drill-
ing depth.
Tighten the clamping screw 26 in this position.
Operation

Starting Operation

Inserting the Battery
Use only original Bosch lithium ion batter-
ies with the voltage listed on the nameplate
of your power tool. Using other batteries can
lead to injuries and pose a fire hazard.
Set the rotational direction switch 7 to the cen-
tre position to protect the power tool against
accidental starting.
Insert the charged battery 16 from the front into
the base of the power tool. Push the battery
completely into the base until the red stripe can
no longer be seen and the battery is securely
locked.
Bosch Power Tools