Vaude Mark 3P Bedienungsanleitung Seite 12

3. Lay out the poles and assemble them. Caution: pay attention to the cor-
4. Insert the pole ends into the corresponding sockets (with the inner and
5. Insert the ridge pole into the respective plastic eyelets, to the front and
6. Starting from the middle place the cords over the ridge pole and hook
7. Anchor the base with tent pegs. The anchoring point can be varied by
8. Anchor the porch and, if necessary, use guy ropes. Please note: It is best to
9. Ensure that there is sufficient ventilation. The porch and air vents are ideal
TakE Down – gEnEral inSTrUCTionS:
• Remove everything from the tent's interior.
• Freestanding tents can be gently shaken out to remove leaves, sand, and
• Turn the tent over with floor facing upward and allow it to dry a bit longer.
• If it's not possible to dry the tent completely before packing it, this should
• As in the tent set up, never pull the poles out of the pole sleeves; rather
12
GAL_TENT_Mark_3P.indd 12
rect positioning of the pole connectors. The long poles point downwards
and the short poles point upwards (a). The cross pole lies over the ridge
pole (A1).
outer socket aligned). Tense the poles (b).
assembly of the outer tent only: insert the pole ends into the sockets of
the outer tent and tense the poles (b1). Continue with point 5.
assembly of the inner tent only: insert the pole ends into the sockets
of the inner tent and tense the poles (b2). Starting in the centre, clip the
inner tent onto the poles (b3).
back in the four upper corners (C) and secure the poles with the hooks
located above the eyelets. Push the pegs in the dome of the tent into the
pole connectors (D).
over the loop below. Then, moving from above to below, proceed to do
the same with the other poles (E). Please note: the tension in the cords can
be altered once the tent is erected (E1).
altering the cord length (f).
wrap the webbings of the guy ropes around the poles (g).
for individual adjustments.
other debris.
be done within 12 hours to prevent the risk of mold and mildew growth.
push them through.
08.08.2011 11:51:50