V2 NEW ROTOR series Handbuch Seite 62

DECLARATION OF CONFORMITY
V2 SpA hereby declares that the products:
MR2-U-433, MR2-U-868
comply with the following directives:
99/05/CEE
ROHS2 2011/65/CE
The full declaration of conformity is available on the website
www.v2home.com in the section:
PRODUCTS / TRANSMITTERS AND RECEIVERS / MR2
DISPOSAL
As for the installation operations, even at the end of this
product's life span, the dismantling operations must be
carried out by qualified experts.
This product is made up of various types of materials:
some can be recycled while others need to be disposed of.
Find out about the recycling or disposal systems envisaged by
your local regulations for this product category.
Important! – Parts of the product could contain pollutants or
hazardous substances which, if released into the environment,
could cause harmful effects to the environment itself as well as
to human health.
As indicated by the symbol opposite, throwing away this product
as domestic waste is strictly forbidden. So dispose of it as
differentiated waste, in accordance with your local regulations,
or return the product to the retailer when you purchase a new
equivalent product.
Important! – the local applicable regulations may envisage
heavy sanctions in the event of illegal disposal of this product.
PRODUCT DESCRIPTION AND INTENDED USE
This receiver is part of the MR series by V2 SPA.
The receivers in this series are intended for use on V2 control
units.
Any other use is improper and prohibited!
• Operates with Royal or Personal Pass series transmitters:
the first remote control to be memorised determines the
mode of operation; Royal or Personal Pass.
Personal Pass Version:
• It is possible to store up to 1008 different codes with
self-learning mode
• Memory full warning: the receiver blinks 15 times
• Self-learning of transmitters managed by radio
• Management of the substitutive transmitter
• It is possible to enable or disable the ROLLING CODE mode
• Basic programming using button P1 or advanced
programming using the PROG2 (version 3.6 or newer)
programming device and WINPPCL software (version 5.0 or
newer)
ATTENTION: Use the receiver MR2 only with V2
equipments
TECHNICAL DATA
Frequency 433,92 MHz
Temperature -20 ÷ +60°C
Sensibility ≥ -103 dBm
S/N > 17dB @ 100dBm m=100%
Size 52 x 35 x 15 mm
PROGRAMMING
NOTE: the first remote control to be memorised determines the
mode of operation; Royal or Personal Pass.
To change the operating mode, it is essential to perform a FULL
CODE ERASING and then memorise the new remote control.
CAUTION: If the receiver is configured in the Personal Pass
mode, to program the BISTABLE and TIMER functions it is
required the use of a PROG2 programmer and of a
WINPPCL software.
IMPORTANT: to memorize the code in the correct way
it is necessary to keep a minimum distance of 1,5 metres
between the transmitter and the receiver's antenna.
The self learning programming system enables the code
memorization and the setting of the following functioning
modes:
MONOSTABLE: it activates the corresponding relay through the
time of TX transmission. When the transmission stops, the relay
goes automatically off.
BISTABLE: it activates the corresponding relay on the first TX
transmission. The relay goes off on the second transmission.
TIMER: the tx transmission activates the corresponding relay
which goes off after the set time (max 7,5 minutes).
868,3 MHz